MOT Stats


Vehicle types : Car : Daihatsu

Daihatsu

ModelTestsPass rateMost common fail reason
Applause560%Parking brake efficiency below minimum requirement.
Atrai2661.54%Fog lamp inoperative or rear fog lamp missing.
Charade1,77554.87%Suspension pin, bush or joint excessively worn.
Charmant333.33%Exhaust system leaking or insecure.
Coo10%Steering rack gaiter or ball joint dust cover missing or damaged.
Copen96670.7%Excessive corrosion to, or weakened structure near any suspension mounting.
Cuore43952.85%Excessive corrosion to, or weakened structure near any suspension mounting.
Domino475%Spring broken or seriously weakened.
F20580%Horn inoperative.
F50333.33%Binding brake.
F50 RV H/T250%Headlamp aim outwith limits.
F552100%n/a
Feroza250%Stop lamp missing or inoperative.
Fieldman28247.16%Suspension pin, bush or joint excessively worn.
Fourtrack1,54651.49%Seat belt load bearing structure strength significantly reduced near an anchorage point.
Grand Move13452.24%Seat belt load bearing structure strength significantly reduced near an anchorage point.
Materia46875.43%Wiper blade missing or not clearing the windscreen.
Midget966.67%Position lamp missing or inoperative.
Mini1100%n/a
Mira1346.15%Windscreen washers not providing sufficient fluid.
Move10352.43%Excessive corrosion to, or weakened structure near any suspension mounting.
Pick Up666.67%Windscreen washers not providing sufficient fluid.
Rocky366.67%Brakes out of balance across an axle.
Sirion5,77067.95%Suspension pin, bush or joint excessively worn.
Sportrak27049.63%Excessive corrosion to, or weakened structure near any suspension mounting.
Terios4,14658.15%Excessive corrosion to, or weakened structure near any suspension mounting.
Trevis1100%n/a
YRV40242.79%Excessive corrosion to, or weakened structure near any suspension mounting.

Tests: 16,387

Average Daihatsu pass rate: 60.93%

Most common fail reasons

#ReasonFail codeCategory%
1Wiper blade missing or not clearing the windscreen.3.4(b)(ii)Major16%
2Excessive corrosion to, or weakened structure near any suspension mounting.5.3.6(a)(i)Major15%
3Suspension pin, bush or joint excessively worn.5.3.4(a)(i)Major14%
4Seat belt load bearing structure strength significantly reduced near an anchorage point.7.1.1(a)(i)Major9%
5Exhaust system leaking or insecure.6.1.2(a)Major9%
6Position lamp missing or inoperative.4.2.1(a)Major9%
7Constant velocity joint boot missing or split.6.1.7(g)(ii)Major9%
8Stop lamp missing or inoperative.4.3.1(a)(ii)Major8%
9Brake pipe damaged or excessively corroded.1.1.11(c)Major8%
10Engine MIL inoperative or indicating a malfunction.8.2.1.2(h)Major7%

Tests date range: 20th May 2018 to 5th December 2018


Contains public sector information licensed under the Open Government Licence v3


Home   Contact   About   Mobile site Share